Cranking out some work on the Greasy Dozen '56 Panhead Build

after playing with the lines on the tank a bit I decided I wanted it to sit a little lower on the backbone so I finished up the back of the tank setction now I just have to go back and finish the bottom seam and I will probably do the mounts from underneath into the bottom of the tank spent the day cleaning parts in the parts washer then pulled down the tank shell I made a few months ago off the wall and started to fit it to the bottom panel just some very early mockup pics of it Cleaned the motor down enough so that I can toss it back in the frame for mockup and fab work it will be getting pulled all apart for a nice freshen up and refinish cleaned the trans down and dropped it into place hopefully gonna get the motor in place tomorrow amd start to line up the drivetrain and set the rear wheel this is just for mockup the trans will be getting pulled apart and the case and cover dechromed and the internals all gone through and anything fixed as needed etc